Free pattern Sheath twist for knives from VasileandPavel.
The part where the knives are kept 24/17” (60 / 44 cm).
Exterior and lid: 5.5 square meters ft (0.5 sqm) of 5 oz (2mm) leather.
Interior: 5 sq. ft (0.4 sqm) of 4 oz (1.4-1.6 mm) leather.
Belts, stripes, handle
Some scraps and a 43/1” (2.5/110 cm) long piece of leather 7-8 ounces (2.8-3.2 mm) for the shoulder strap. First, it is advisable to cut long pieces.
Tough leather 2.5 oz (1 mm) thick.
1mm waxed polyester thread for 1.5mm holes.
cutter, needles, 1-1.5 mm punch, hammer, paper masking tape.
2 buckles x 1.2" (30mm)
1 x 1 inch (25 mm) buckle
2 X 1” (20 mm) D-Rings
Step 1: print on paper of desired size 1:1 (100%); How to print paper 1:1?
When you print it, check the printer properties to not change the settings according to the page, it should be "none", also you need to set all margins to "0" (if your software has a margins option, do this, if not, just leave it there) then you will get a 1:1 property printout.
Step 2: stick them on heavy craft paper.
Step 3: cut the paper and do it!