Roughing

Discussion of issues on working with the skin
Post Reply

How do you sand your leather?

Double vision on a large machine
0
No votes
Sawing on a small machine
0
No votes
Cutting on the device
1
100%
By hand with a knife
0
No votes
I'm not looking for easy ways - with sandpaper
0
No votes
Other
0
No votes
 
Total votes: 1

User avatar
abzalacom
Site Admin
Posts: 21
Joined: Tue Nov 23, 2021 9:29 am
Location: Belebey
Contact:

Roughing

Post by abzalacom »

The topic of drilling (thinning) of genuine leather.
User avatar
abzalacom
Site Admin
Posts: 21
Joined: Tue Nov 23, 2021 9:29 am
Location: Belebey
Contact:

Splitting manual machine

Post by abzalacom »

Tired of splitting with a knife, so I bought a manual sander. There is nowhere to put the machine and there are no such volumes.
Photo (click to view)
The set included screws and a hexagon.
The set included screws and a hexagon.
Also a pack of blades. The blades are dull, so I put Stanley.
Also a pack of blades. The blades are dull, so I put Stanley.
The overhang of the blade must be immediately adjusted by yourself.
The overhang of the blade must be immediately adjusted by yourself.
The springs are powerful, it is impossible to work without attachment to any surface.
The springs are powerful, it is impossible to work without attachment to any surface.
Wide surfaces cannot be doubled, only stripes up to 6 centimeters.
Wide surfaces cannot be doubled, only stripes up to 6 centimeters.
The seller stated that it was stainless steel. but everything is a little, but it is magnetic.
The seller stated that it was stainless steel. but everything is a little, but it is magnetic.
The racks are crooked, but the car works.
The racks are crooked, but the car works.
The shaft is mounted on bearings, but there is play.
The shaft is mounted on bearings, but there is play.
It will not be possible to obtain a perfectly mirrored surface, but it is possible to reduce the thickness of the strip.
It will not be possible to obtain a perfectly mirrored surface, but it is possible to reduce the thickness of the strip.
If you have any questions or suggestions, then ask.
Post Reply